Skill Claude Code
Use when developing firmware on ESP32/STM32/RP2040/nRF52, experiencing DMA overflow, SPI timeout, LCD blank display, frame corruption, GPIO conflicts, sensor reading errors, Wi-Fi disconnect, or needing driver configuration, hardware debugging, display/GUI setup, protocol implementation, serial monitoring. Use even if…
Skill Claude CodeCodex needs its repo
Guide for embedded systems development on ESP32, STM32, RP2040, nRF52 chips. Use this skill whenever the user mentions embedded systems, firmware development, MCU programming, hardware drivers, sensors, LCD displays, IMU devices, SPI/I2C/UART interfaces, compilation, debugging, remote monitoring, Wi-Fi/BLE/MQTT…
Hook Claude Code
Runs when a session starts on embedded, hardware, driver, LCD, display, ESP32, STM32, RP2040, nRF52, sensor, firmware, SPI, I2C, UART and GPIO, executing session-start.cmd. From lhbsaa/embedded-dev-skill.
Skill Claude CodeCodex
Use before any embedded development - explores hardware requirements, confirms configuration, validates feasibility, saves design spec.
Skill Claude CodeCodex
Use when hardware configuration confirmed - creates detailed implementation plan with bite-sized tasks, exact file paths, complete code steps.
Skill Claude CodeCodex needs its repo
Use for LCD/GUI projects after verification passes - captures display via camera, analyzes layout/font/color, detects display issues.
Skill Claude CodeCodex
Use when implementation plan is ready - executes plan task-by-task with two-stage review (hardware spec then MISRA C).
Skill Claude CodeCodex
Use after implementation complete - runs build-flash-monitor loop, verifies runtime behavior, no completion claims without fresh evidence.
At most 3 mods per repository are shown here, and a mod shipped inside a plugin is left to that plugin's page — the rest are on their repository pages: